There are a number of trench drain manufacturers that sell 4 inch wide (100 mm) polymer concrete channels. In general, each manufacturer offers two grades of channel – “ residential and commercial.”  Hubbell, the maker of Polycast Trench Drain, is one of these companies. In this article, their residential product, 400 series, is compared to their commercial grade product, 600 series.

The photo to the left compares a 2 foot long section of a 400 series (left) and 600 series channel (right). Both products are made from the same polymer concrete composition, which is a mixture of silica sand and epoxy resin. This material, while taking on some of the polymaic properties of the resin, displays the compressive strength of a concrete due to the high amount of silica sand. And though the material has the compressive strength which allows it to withstand heavy traffic while in service, it behaves as a ceramic and will crack upon impact or if dropped prior to installation.
Both channels have a similar 4” interior width and are available in 2 foot and 4 foot lengths. And from a functionality point of view, in low flow, low load applications both products perform equally. Most residential driveway applications would fall into this category.

Some of the differences between the 400 and 600 series are apparent in the above photo. Wall thickness of the 600 series is greater, which allows for heavier load bearing capabilities. Also, the channel end of the 600 series has a more integral male-female connection than does the 400 series product. Additionally, the grate used on the 400 series rests on top of the channel, while the 600 series channel actually has a recess within the channel for the grate to lie. However, a major difference between the two products is that the 400 channels are all non-sloped, while the 600 series channel are pre-sloped. The pre-sloped character of the 600 channel insures that water flows more quickly, thus allowing for higher overall flow rates. 600 Series channels can still be purchased without slope and are needed when designing complex drainage systems.
The 400 series product comes with a Class B galvanized steel slotted grate and is capable of withstanding loads from most automobiles. This is the only grating option. With the 600 series, you get a wider selection of grating options. You can get a Class B galvanized steel slotted grate, shown below. Or, you can upgrade to a cast iron or ductile iron grate for heavier loads. Stainless steel grates are even available for applications in a corrosive environment. In fact, there are 19 different grates options and four frame option for the 600 series channels.

The frames available with the 600 Series include a galvanized steel channel protector (shown above). This is a steel edge covering that keeps the channel from deteriorating while in use and helps increase the load capabilities of the system. The channel protector is also available in stainless steel. For heavy load capabilities (fork truck or airline) a cast iron or high density poly ethylene (HDPE) frame is used to cover the channel prior to inserting a ductile iron grate.

A final comparison between these two products is price. The 400 series product is manufactured for economy. It is a light duty product that is easily manufactured due to its uncomplicated dimensioning. It has only one grate option. Because of this, it sells for approximately 30% less expensive than the comparable 600 series product.
With the 600 series, you get flexibility and value. Though more expensive than the 400 series, the 600 series allow for higher load capabilities which can be further improved by changing your frame or grate. The 600 channels are more expensive due to the sturdier and pre-sloped design. And, of course, your choice of grating will directly influence your final $/foot price, especially if your application requires a stainless steel grate.
For a quotation on a 400 or 600 series trench drain system, email michael@trenchdrain.biz or call EarlyCut Supplies at 610-882-3630.